Bondtech LGX® Lite
Larger drive wheels for increased filament grip
Filament pre-tension lever, for repeated results
Drive wheel maintenance window for easy cleaning
Compact, lightweight and centered filament path for increased performance and compatibility
Multiple mounting hole patterns for easy and flexible setup
Compatible with round Nema14 stepper motors
Uncolored nylon housing without chemical post-processing
Contents:
1x BONDTECH LGX® Lite extruder
1x LDO Nema14 round 20mm pancake stepper motor;
1m long connection cable
with JST-XH 4-pin connector
1x 2mm hex wrench (recommended tool);
1x Powered By Bondtech sticker
The Bondtech LGX Lite is a filament feeder based on the LGX Large Gears eXtruder and uses Bondtech's new Dual Drive Technology with larger drive gears.
This extruder supports only 1.75 mm filaments
e-steps value: 562 with 16 microsteps
Drive wheels : hardened steel;
Material compatibility : abrasive; rigid; semi-flexible; flexible; and soft.
Mounting holes: M3
Fixing pattern: bottom (4 points); right (2 points), front to motor (2 points), top (1 point).
Hole on top of LGX® Lite : 5 mm depth
Holes on the side of the LGX® Lite : 5 mm depth
Holes on the bottom of the LGX® Lite : 5 mm depth
The maximum tightening torque of the extruder screws is 0.3 Nm
Max. Operating ambient temperature : 90 °C
Max. Operating temperature of stepper motor: 120℃ / 750 mA.
LGX® Lite net weight: 48g
LGX® Lite with motor Net weight: 141g